Operating Manual
RO-Control NAVY Serie
s
No.8721
No.8722
No.8723
No.8724
Seite
5
2. Calibrate the throttle on a pistol grip transmitter:
a) a) Pull the throttle back to full throttle position and hold it in
this position, then connect the battery to the regulator and switch
it on, 2 seconds later the engine will emit two short beeps (beep,
beep), the full throttle position has been accepted.
b) Move the throttle lever to the neutral position, a long tone
(beep----) is emitted, which means the calibration is complete.
Notice:
While the acoustic signal is being output, the
red LED lights up simultaneously.
3.
Calibrate one transmitter throttle lever with joysticks:
a) Pull the throttle stick into the forward position, then
connect the battery to the regulator and switch it on, 2 sec.
later the engine switches off two short tones (beep-, beep-),
the full throttle position has been accepted.
b) If you want to set the throttle range to the "half stick
travel", move the throttle lever to the neutral position. If you
want to use the full stick travel, move the throttle stick to
the lower position. A long tone (beep----) is emitted, i.e.
calibration is complete.
Notice:
While the acoustic signal is being output,
the red LED lights up simultaneously
.
Normal switch-on procedure:
1.
Move the throttle or throttle control stick to the lower position and switch on the
transmitter.
2.
Connect the battery to the controller and switch on the controller.
3.
The motor emits a series of tones indicating the number of LiPo cells. If only one
tone is output, this indicates that the undervoltage cutoff is active. For
Nickel
cells you can deactivate the function during programming, for LiPo cells you
must not do this, the cells could be destroyed due to a deep discharge.
4.
One second later, the motor emits a long tone indicating that the "Motor Off"
position has been detected. If the control transmitter is not in the correct
position, a permanent warning tone (beep, beep) is emitted.
5.
Move the throttle lever / stick forward, the engine starts.
Summary of Contents for RO-Control NAVY 120 A
Page 1: ...ro navy Operating Manual...
