INSTALLATION
Comply with the
safety recommendations
indicated above and hereafter when installing the
appliance .
1. Make sure that the mains voltage is as indicated on the rating label of the appliance and that
the electrical system is grounded and equipped with a switch.
2. Install the appliance in a
DRY, PROTECTED place
, far from water sprays or splashes, heat
sources, open flames and inflammable substances.
Place the appliance on a
flat, horizontal, stable surface
where it cannot tip over.
3. Make sure the switch on the appliance is in the "OFF" position and plug it into a socket
protected by a suitably rated circuit breaker (MCB) or fuses.
Do not use an adaptor plug.
4. Stretch the power cable out to full length.
Do not
let it pass over sharp edges or hot surfaces.
Do not
let oil spill on it.
Do not
let the power cable hang loose from the counter on which the
appliance stands.
5. To use the appliance more easily, we suggest that the appliance is placed on a table or counter
top so that the juice spout and the controls face towards the right side of the user (suggested
height for counter top from a round level: 90 cm (36 inches), to be adjusted according to the
height of the user).
USE
Make sure the tabletop and feet are clean to ensure grip during operation.
Before first use:
rinse all of the parts that will have contact with food in running water i.e.;
food pusher, juicer cover, basket, bowl, pulp container and pulp retainer*. To disassemble the
various parts see Fig. 8 and Fig. 9.
* Not standard equipment on all models.
Suggestions:
to reduce the cleaning procedures to a minimum we suggest placing a
biodegradable plastic bag inside the pulp container and folding the top of the bag over the
edge of the pulp container (see Fig. 5). By using this method, once you have finished using
the appliance, you can put the waste directly into a composting or waste bin.
Wash the fruit or vegetables you will use.
NOTE:
Many types of fruit and vegetables for example apples, carrots and cucumbers fit
through the feed chute without having to be cut into pieces. When you make juice from carrots
it is a good idea to insert the larger end of the carrot first, or to cut the carrot in two or three
pieces.
For models with feed chute ø 50 mm, use the latter to juice carrots. To optimize the juice output
chop fruit into smaller pieces.
Ensure that the juice extractor is correctly assembled. Ensure that the basket is properly
cleaned before each use.
Check to see that the ON-OFF button is in the “OFF” position and that the locking arm is
hooked on to the juicer cover.
3
2
1
6
Summary of Contents for CEADO ES300
Page 15: ...Cod 80412...
