Waste Water Tank Dumping:
To dump the exterior black waste water tank:
1.
Turn the battery disconnect switch to the “ON”
position, if not already on, (located on the
monitor panel).
2.
Remove sewage discharge hose from storage, (see
Picture G-P12).
3.
Insert the discharge outlet into the waste
receptacle.
4.
Open the valve on the sewage hose,
(see Picture G-P12).
5.
Open the black water tank valve
(black water tank has a black handle),
(see Picture G-P9).
6.
Open the driver’s side fuel door, press and hold the
macerator pump switch until the tank is empty,
(see Picture G-P11).
To dump the grey waste water tank:
1.
Open grey water tank valve
(grey water tank valve has a grey handle).
2.
Repeat step 6.
3.
Close all valves.
4.
Return sewage hose to its storage compartment.
5.
Turn battery disconnect to the “OFF” position.
NOTICE:
It is recommended to always dump the black
water tank first, then the grey water tank to flush
out the sewage discharge system.
NOTE:
If macerator should get clogged you will have to
push and turn the manual macerator crank
handle to dislodge any debris that might be
blocking the macerator, (see picture G-P10).
WATER SYSTEMS
D
Do
occ N
No
o::
21906540-RSAD
R
Re
ev
v::
00
C
Co
op
py
yrriig
gh
htt ©
© H
Ha
an
nm
ma
arr M
Mo
otto
orr C
Co
orrp
po
orra
attiio
on
n 2
20
00
05
5
G
G--5
5
Picture G-P11:
Macerator pump switch located at
the base of the seat pedestal (red button) .
Picture G-P12:
Sewage discharge hose storage
located in driver's side storage drawer.
Picture G-P10:
Macerator manual crank handle
located to the right of the holding tanks discharge
handles.
