Page 4 of 6
12.
Position front mounting feet as far forward as possible. Determine which two pre-drilled
holes will be used. You may choose to drill an additional hole in the foot bracket if
needed. Center punch the hole locations and drill a 3/8” hole at each location. Install a
foot-mounting bolt
(C)
two flat washers
(G)
one on each side of the bed rail. A lock
washer
(D)
and a nut
(A)
13.
Check to be sure that the
#4 Rear Bar
clevis pins can be removed and installed easily. If
not, check and adjust the rack alignment.
14.
With rear mounting feet in position, determine which two pre-drilled holes will be used.
You may choose to drill an additional hole in the foot bracket if needed. Center punch the
hole locations and drill a 3/8” hole at each location. Install a foot-mounting bolt
(C)
two flat
washers
(G)
one on each side of the bed rail. A lock washer
(D)
and a nut
(A)
15.
Complete the installation by tightening all rack assembly hardware.
Note:
To reduce the risk of stainless steel fasteners galling while being tightened, apply only
light pressure with minimal interruptions. Impact wrenches or other air-operated devices are
NOT recommended. A high quality nickel anti-seize can be used but is not required.
