AN505 User’s Manual
2
2.2 Charging by car charger
1. Plug the car charger into the device’s USB port on its side panel.
2. Plug car charger’s the other end into the car igniter.
3. To avoid damage caused by instant current when igniting the car, please plug in
the car charger after ignition.
2.3 Power supplied by built-in battery
When disconnect with external adapter, the device is powered by its built-in
Li-polymer battery. The icon [ ] on the main menu shows the current remaining
battery volume. When connect with external adapter, the device is powered by the
external adapter.
2.4 Install the car mount system
1.
Take off the protected film on the bottom of the suction. Then put the bracket onto
a suitable location of your windscreen or side window, make sure the window or the
suction or windscreen is clean and without water and some dirty things inside, fixing
the stand on that position. Never place the stand where the driver's field of vision is
blocked. If the car's windshield is tinted with a reflective coating, an external antenna
(optional) may be needed to route the roads. The external antenna is stick to the top of
the car through the window. When closing the car window, be careful not to pinch the
antenna cable (Cars with an anti-jam window design may automatically leave
adequate space as needed.).
2.
Install the holder into the car bracket, and then put PND into the holder.
3.
To remove the bracket, press 2 side buttons, pull left lightly and then take off the
suction. If the bracket still doesn't detach from your windscreen, tug gently on the
