ROADMASTER, Inc. 6110 NE 127th Ave. Vancouver, WA 98682 800-669-9690 Fax 360-735-9300 www.roadmasterinc.com
All specifications are subject to change without notice.
853649-02 11-18
Even Brake
replacement motorhome monitor,
ICX transmitter or second vehicle kit
part numbers 9410, 9420 and 9430
Programming Instructions
Time Tested • Time Proven
CAUTION
Check the Even Brake serial number before continuing.
This kit is compatible ONLY with Even Brake systems with serial numbers up to 27,496. Check the serial number
on the bottom of the Even Brake unit before proceeding.
T
he Even Brake motorhome monitor and the ICX
transmitter must be programmed as a set. If a re-
placement monitor, a replacement ICX transmit-
ter or a second vehicle kit is to be installed, follow the
instructions below.
Program the motorhome monitor
Until both the motorhome monitor and the ICX trans-
mitter are programmed as a set, the motorhome monitor
will not receive the signal from the ICX transmitter. Follow
the instructions below to program the monitor.
A second 12-volt outlet (in addition to the towed ve-
hicle’s) will be necessary.
1.
Before programming, first install Even Brake in the
towed vehicle — follow the installation instructions. Even
Brake must be completely installed, with both the ICX
transmitter cord and the power cord plugged in.
Read the installation instructions and the owner’s
manual before installing or operating Even Brake.
Failure to understand how to install or operate Even
Brake could result in property damage, personal in-
jury or even death.
Note: Before transferring to a second (or third, or
fourth) vehicle, it may be necessary to adjust the feet to
maintain stability. Refer to the section titled “Adjust the
feet and the seat pad” in the Even Brake owner’s manual.
continued on next page
2.
Next, plug the motorhome monitor power cord into
the second 12-volt outlet. (This outlet must be receiving
power for the monitor to operate). The LCD text display
will read “Even Brake.”
3.
Now, press the “Dim” button on the motorhome monitor
(Figure 1) for approximately six seconds, until the LCD
text display reads “Receiver is in Learn Mode.”
9410 Kit
9420 Kit
9430 Kit
1. Press the “Dim” button
for six seconds.
2. LCD text display reads
“Receiver is in Learn Mode.”
Figure 1
