12
TO AVOID DAMAGE ALWAYS FOL-
LOW DISCONNECT PROCEDURE BE-
FORE WELDING. SEE SECTION 4.7
WELDING PRECAUTIONS
IMPORTANT
NEVER STRIKE THE PICK ON THE
CARBIDE TIP. THE CARBIDE CAN
BREAK OR CHIP AND CAUSE INJU-
RY.
WARNING
ALWAYS WEAR EYE PROTECTION
WHEN PERFORMING THIS OPERA-
TION. HARDENED TOOL AND CAR-
BIDE PICKS CAN SHATTER CASUING
INJURY.
WARNING
REMOVING AND INSTALLING TEETH:
The fork type pick tool included with the cold
planer
should be used to remove the picks from
the holders. Insert the fork into the groove on the
tool and strike the tool with a hammer. In the
event the pick tool is not available, a punch may
be inserted into the bottom of the holders can be
used to dislodge the pick.
For installation, the fork type tool should be in-
serted into the groove on the tooth and struck
with a hammer. Also, if the tool is not available, a
length of pipe with a 3/4 to 1 inch inside diameter
can be placed over the pick to protect the carbide
from a direct hit. Striking a small piece of wood
placed on the pick to absorb the shock will also
prevent damage.
DO NOT STRIKE THE CARBIDE TOOTH TIP
WHEN INSTALLING TEETH.
RoadHog does not warrant ANY ground en-
gaging parts ( drums, teeth, holders or bases )
against wear, unless the wear is determined
by RoadHog to have been caused by an engi-
neering or manufacturing defect.