WAXING SYSTEM INSTRUCTIONS
Before you begin, make sure your car is clean and dry. The work area should be dry also.
1. Place clean pad cover securely on pad as shown (A). Do not apply synthetic wool pad cover for
waxing.
2. Spread about a heaping teaspoonful of wax, evenly over the entire surface of the pad cover (B).
3. Apply about twice that quantity of Cleaner / Glaze over wax on pad cover (C). Do not apply
directly to car. This first application should do 1/3 of the car. For the second and third applications
of wax and cleaner/glaze, use half the quantity stated above. Pad cover will not absorb as much
when reloading.
4. Always start and stop polisher on or against the car surface. (D).
Hold extension cord over shoulder and do flat surfaces first-hood, trunk and roof. Cover areas
quickly with broad, sweeping strokes in a criss-cross pattern. Do not press down on polisher. The
machine’s action, not pressure, does the best job.
5. Finally, remove pad cover and hand polish all hard-to-reach surfaces; under the bumpers, around
the door handles, etc. Put a clean pad cover on the polisher. Remove chemicals in the same
order they were applied. Synthetic wool pad may have better work result. Use long, sweeping
strokes in a criss-cross pattern. Do not press hard. Let the polisher do the work.
- 4 -
5. The most common error, however, is applying too much wax and cleaner/glaze. If pad absorbs
too much chemical, it will not last as long. And polishing is more difficult and takes longer.
6. If pad cover continually comes off pad, you may be using too much wax and cleaner/glaze.
7. If wax seems difficult to buff, you may have used too much wax.
8. Use only mild soap and damp sponge to clean polisher. Do not immerse any part in liquid. If
polisher needs repair, use only identical replacement parts as listed in the following.
ITEM
45001
TOP HOUSING
45002
BOTTOM HOUSING
45006
PAD HOLDER
45007
PAD
45008
PAD COVER
SPECIFICATION
120 VOLT AC, 60 HZ
RPM: 2600
RATED CURRENT: 0.65 AMPS
WEIGHT: 2.35KG
A
B
C
D
