www.ro-man.com
T: 01823698813
Installing the needle valve
Connecting the red pipe to the saddle valve is not difficult, remove the nut for the valve and
put it over the pipe, then push the small copper ring over the end of the pipe and push the
insert into the end of the pipe. Then push the end of the pipe into the valve assembly and
tighten the nut (DO NOT over tighten).
When fitting the valve make sure the saddle valve is in open position. With a spanner fit the
saddle valve to a 15-9 mm pipe. Once the saddle assembly is fitted put the other end of the
red pipe in water container and close the tap on the saddle valve to pierce the pipe, you
may need to open and close this several times to clean the bore off.
