1
Automatic needle threader
DH63
Please retain these instructions for future reference. These instructions are also
available in other formats.
General description
If sewing is your passion but threading needles is getting tougher, this handy gadget
can help remove that stress and frustration for you as it enables you to thread a needle
easily and simply.
Orientation
The needle threader is housed in a rectangular plastic case that is 7.3cm (2.9 inches)
wide, 4.5cm (1.75 inches) high and 2.5cm (1 inch) deep. You will feel one end open,
which has a raised lip to help identify it, and the bottom has a profiled lip on each side
that run the length of the case.
Above this is a corresponding moulded strip inside the case. This forms a groove that
the threader slides into securing it for storage. On one side of the inside of the case
just above the retaining groove is a square tube with a small white plastic stopper, this
is for storing your needles - two needles are included.
Place the needle threader in front of you so that the two white semi-circular buttons are
facing towards you. These are spring loaded and slide from the central position to the
outer edge of the threader. They are slightly offset, the right one above the left and
when slid outwards they push a metal probe from inside the unit through the
corresponding needle tube on the outer edge of the threader.
At either end of the needle threader is a vertical needle tube, the right one has a white
top and is for fine needles, the left one has a black top and is for bigger needles. On
the inside edge of each tube there is a recessed area which forms a slit and this is
where the thread is placed.
Using the product
The underside of the threader is recessed. Hold the plastic case in one hand and place
your thumb into the recessed part of the base then simply slide your threader out of the
case by gently sliding them apart.
