Quick Start Guide:
A more complete guide to the installation is featured later
1.
Connect the input RTX connector to transceiver with 50 Ohm patch
cable
2.
Connect the ANT Output of the Amplifier to SWR Bridge / Wattmeter
(If required), and then the Antenna (50 Ohm load Impedance)
3.
Connect the Amplifier DC power Cable to a suitable 13VDC (± 1V)
Power Supply or Auto Battery. Pay attention to the correct polarity
4.
Connect PTT cable if required to the transceivers PTT OUTPUT,
(The Amplifier may be used without this connected, however con-
nection is recommended for SSB operation. PTT is Active Low )
5.
Make sure that the amplifier is switched off
6.
Adjust the Transceivers RF output power to 10W (15W max) if it is
capable of more than 10W output
7.
Switch on the Amplifier and start operating
8.
Check that the antenna VSWR is acceptable with the amplifier in
use. Any large increase in VSWR indicates that the Antenna is not
suitable for the power being used. Operation should be halted im-
mediately to avoid damage to the Amplifier / Radio / ATU etc.
