©2010 RLE Technologies. All rights reserved. RLE is a registered trademark, and
SeaHawk, Falcon, and Raptor are trademarks of RLE Technologies. All other trademarks
or registered trademarks are the property of their respective companies. Although the
information contained in this document is believed to be accurate and correct, RLE
Technologies assumes no responsibility, and disclaims all liability, for any damages
resulting from the use of this information or any error or omission in this document. RLE
Technologies does not warrant, guarantee, or make any representations as to the
performance, fitness for use, safety, or reliability of any existing or future wiring,
equipment, additions or modifications to equipment, or any other component of the original
or modified system. Specifications are subject to change without notice.
Part number 110052 Rev. 2.0 6/2010
104 Racquette Drive
Fort Collins, CO 80524
970.484.6510
www.rletech.com
6
Configuring Network Communication
IMPORTANT
Consult your IT administrator before performing these steps.
1
From the home page of the LD2000’s web interface, select the
Configuration Menu link. Then, select Network/IP Settings from the
Configuration Menu.
The Network/IP Configuration page displays.
2
Enter the values for IP Address, Net Mask (subnet mask), and Def Route
(default gateway) provided by your IT administrator.
Once you enter the values and click the Submit Changes button, the
LD2000 saves the changes and reboots. The system status LED on front of
the LD2000 stops flashing.
3
Reset the computer to its original IP address and subnet mask.
Note:
This step might require assistance from your IT administrator.
The computer and the LD2000 are now both configured to communicate on
the network.
4
Connect the computer and the LD2000 to the network.
5
From the computer’s Web browser, go to the new IP address of the LD2000.
6
When prompted, enter the user name and password to verify network
access to the LD2000 (as you did in
step 4
in the previous section).
If the login window for the LD2000 does not display:
a
Verify that the cables are firmly attached.
b
Verify that you entered the correct IP address for the LD2000.
c
Verify that the Status light on the top of the LD2000 is green.
For troubleshooting and additional configuration information, consult the
LD2000
User Guide
available at www.rletech.com
Select Network Settings
LD2000 Default Values
IP address: 10.0.0.188
Subnet mask: 255.255.255.0
Use values provided
by IT administrator