Page 4
20. Install the rear trans cover and tie bar onto the new wheely bar #14 supplied with the kit. Use a small drop
of red loc-tite on the bolt that goes inside the trans case and bolts to the lower wheely bar. This will insure
the bolt does not vibrate out and ruin the gear set.
21. Bolt the wheely bar to the transmission case. Install the 2 screws left out earlier as this bolts the trans
case gear cover to the trans.
22. Set your gear mesh and make sure all screws underneath are now tight.
23. Install the body post mount #9 supplied with the kit. Push this through the black body mount on the funny
car body. Next, bolt it in with the screw supplied in the kit.
NOTE:
It is a little hard to push the body post
through.
24. Install your 12 mm axal spacers #10 onto the rear axels. Install the pin through the axal then push the
plastic hex over the axal until it snaps on. You are now ready to install all four tires.
Caution:
You must use
these rear axal hub spacers or similar ones of the same width or wider or the tires will hit the body.
www.rlchobbies.com
If Our Name Is On It, Rest Assured It's The Worlds Finest
(732) 269-5628
Tie Bar
Small drop of red loc tite
Install
#9
#10
#14
