82-5201-01 Email/Text Generator Operator’s Manual
Wiring
•
9
2. If using a 9 - 12 VDC power source:
a. Disconnect the factory-installed red and black wires from the email/text generator’s input
terminals.
b. Route the DC wires through the strain relief bushing on the bottom of the housing.
c. Connect the power source’s “+” line to the “+” terminal on the DC terminal strip.
d. Connect the power source’s “-” line to the “-” terminal on the DC terminal strip.
Figure 4: DC Wiring
3. Wire the 2 terminals for each Input Contact to the contacts they are intended to monitor. The
inputs can monitor a normally open (NO) contact or a normally closed (NC) contact.
4. Tighten the screw on the strain relief bushing to secure the wires.
5. Turn on the power source.
-
+
2
1
Input Contacts
3
Relay Contacts
DC Power
Source
Common
NO or NC
Common
NO or NC
4
