2 • 35-3010RK-05 Sample-Draw Detector
Description
This section describes the components of the
35-3010RK-05 sample draw detector head
. The
sample draw detector consists of the housing, flow system, and detection system.
Figure 1: Sample Draw Detector Component Location
Housing
The sample draw detector’s fiberglass housing is weather- and corrosion-resistant. It is
suitable for installation where general purpose equipment is in use. The housing door is
hinged on the left side and is secured by two latches on the right side.
Four mounting feet are attached to the back of the housing (one at each corner). Use the
mounting feet to install the housing to a vertical surface. Use the two conduit hubs on the
bottom of the housing to make wiring connections.
Amp 2
H2S Dummy
Plug
Preamp
Circuit
Board
Flow
Block
Amp 1
Hydrophobic
Filter (AcroPak)
Pump
Combustible
Dummy Plug
Oxygen Sensor
CO Sensor
Exhaust Fitting For 1/4"
OD Rigid Tubing
3/4 Conduit Hub, 2X
Charcoal Filter
Inlet Fitting For 1/4"
OD Rigid Tubing
Reset Switch
Main Circuit Board
