5.4.5 Setting up the synchronisation bus
The synchronisation bus is used for synchronous
movement of the drives which are connected to the
various control units (MultiControl II duo and
quadro).
Up to 8 control units can be connected to each
other via the DATA interfaces using a BUS cable.
In the process, different control units can be mixed
with each other.
If there are more than two connected control units,
the BUS cable must be equipped with a termi-
nating resistor (120 Ohms) at both the start and
end.
Only control units with the same software and
hardware versions can be connected to each other
Personnel:
n
Assembly staff
Protective equipment:
n
Protective clothing
n
Safety shoes
Prerequisite:
n
The mains cable is disconnected from the voltage supply.
Fig. 25: Connecting control units
1.
Connect the BUS cable (Fig. 25/1) to the DATA interfaces on
the control units (Fig. 25/A + B).
Synchronisation bus
Connecting the synchronisation
bus
Connecting 2 control units
Assembly
Connecting the accessories > Setting up the synchronisation bus
20.08.2021
Control unit RK MultiControl II duo/RK MultiControl II quadro
158
Summary of Contents for RK MultiControl II duo
Page 115: ...Anhang Anhang 20 08 2021 Steuerung RK MultiControl II duo RK MultiControl II quadro 115...
Page 116: ...Anhang 20 08 2021 Steuerung RK MultiControl II duo RK MultiControl II quadro 116...
Page 228: ...Appendix Appendix 20 08 2021 Control unit RK MultiControl II duo RK MultiControl II quadro 228...
