RK Rose+Krieger RK MonoLine R, Assembly Instructions Manual

Page: 100 / 132

3. Insert the gear ring (Fig. 18/4) into the screw-in hub
(Fig. 18/2).
4. Slide the coupling’s clamping hub (Fig. 19/2) onto the motor’s
motor shaft (Fig. 19/3).
5. Tighten the screw (Fig. 19/1) on the clamping hub:
Size Screw size Tightening torque [Nm]
40 M3 1.4
60, 80 M6 10.5
120 M8 25
6.
The following applies to the RK Mono-
Line Z 40:
Before the coupling housing is assembled,
the centring ring is inserted into the pulley
box.
Place the coupling housing (Fig. 20/2) on the pulley box
(Fig. 20/1).
7. Tighten 4 screws (Fig. 20/3) alternating diagonally:
Size Screw size Tightening torque [Nm]
40 M5 5.9
60, 80, 120 M8 25
8. Place the motor plate (Fig. 21/2) on the coupling housing
(Fig. 21/1).
9. Tighten 4 screws (Fig. 21/3) alternating diagonally:
Size Screw size Tightening torque [Nm]
40 M5 4
60, 80, 120 M6 10
Assembling the clamping hub
Fig. 19: Assembling the clamping hub
Assembling the coupling housing
Fig. 20: Assembling the coupling
housing
Assembling the motor plate
Fig. 21: Assembling the motor plate
Assembly
Assembling optional modules > Assembling the motor
14.10.2021 Linear unit RK MonoLine R/RK MonoLine Z 100