RJX Hobby CAOS 330, Assembly Manual

Page: 3 / 9

TO PREVENT LOOSE SCREWS AND BOLTS
Regardless how tightly nuts, bolts and screws are tightened,
they slowly loosen over time due to vibration of the helicopter.
Should this happen, you will lose control of the helicopter
which may cause severe damages or very potential dangerous
situation.
We strongly recommend that you apply thread lock to any
nuts, bolts or screws. There are two types of thread lock, blue
(medium) and red (hard).
Clean the nuts, bolts and screws with Alcohol (or
similar) before you apply the thread lock.
Use blue thread lock on screws that have to be
removed regularly, and
Red thread lock for screws that should be fixed
permanently.
1. Use CA: (Super glue or similar) at this point
2. LOCTIDE 243 ( blue ) - LOCTIDE 648 ( red ):
Remove oil and grease then apply shown thread lock.
(This applies throughout the manual)
3. GREASE: Remove oil and grease. (This applies
throughout the manual)
Items required to complete the RJX CAOS 330
- PCM or 2,4 Ghz Radio System
- CC3D or NAZE 32 Control Board
- 4x 1806-2207 Type 2000-2200 kV Brushless Out runner
Motor
- LiPo Pack 3S- 6S 1300 up to 2200 mAh (depending on
setup)
- 4x 10A-30A ESC (if not delivered)
- 5x3 – 6x4,5 CW/CCW or 3D Propeller
- LiPo Charger
Tools required (not included)
- Allen Drivers 1,5 mm - 2 mm - 2,5 mm - 3 mm - 4 mm
- Philips Drivers large - middle - small
- Nut Drivers 4,5 mm - 5,5 mm - 7 mm
- Cutter
- Universal Pliers
- Sandpaper
- Cyanoacrylate (CA - Superglue)
Page 3