Installation Manual
Neutrino LED Headlights with Halo
Vehicle Can-Am Renegade Gen 2 2012-2019
Also fits Maverick 1000R & Renegade Gen 1 2008-2012 Rev: 2.0
Page 10
Now its time to install the halo harness which is very simple.
The cable harness is made to fit both the Renegade and Outlander
wich makes it a bit to long for the Renegade. Just make a
loop on the cable and use the zip ties to secure it
Use the 12v socket to connect
the halos, make sure to use
+ and ground correctly. The
halo cable have a 2 way fas-
ton connector on both the +
and - cable. Just remove the
stock cables install the halo
harness cables and then rein-
stall the oe cables on the
faston connector and you are
done.
Halo harness included
Each Neutrino light have a sealed Deutsch connector, use the 4
Deutsch connectors on the halo harness and connect them with
the ones on the lights , the right side will have 2 and the left
side 2 it does not matter how you choose to connect them because
they all have 12v+ when ignition is on.
If you only
want the ha-
los to be on
choose this
mode on the
key
If you want
to combine
the halo with
high or low
beam choose
this mode on
the key
