2101
NITRO PRO STOCK DRAG KIT
2104
NITRO PRO MOD DRAG KIT
THANKS FOR BUYING RJ SPEED’S NITRO DRAG KIT . IT IS A LITEWEIGHT CAR MADE FOR STRAIGHT LINE
DRAG RACING AND CAN BE BROKEN IF RUN INTO SOLID OBJECTS AT HIGH SPEED. YOU WILL NEEDTO PUR-
CHASE A .12 TO.18 SIZE SMALL BLOCK ENGINE, CLUTCH SETUP, AND EXHAUST SYSTEM. SEE OUR SEPA-
RATE SHEET FOR INFORMATION AND SUGGESTIONS. IT REQIURES A 2 CHANNEL RADIO WITH 2 SERVOS .
(STANDARD OR MINI SERVOS WILL WORK FOR THE THROTTLE AND STEERING ). YOU WILL NEED A SMALL
PAIR OF PLIERS, AND A 1/4” WRENCH OR NUTDRIVER. HEX WRENCHES TO FIT THE SOCKET HEAD SCREWS
ARE INCLUDED . YOU WILL ALSO NEED PAINT FOR THE LEXAN BODY AND WING, AS WELL AS NITRO FUEL
FOR THE ENGINE. TAKE YOUR TIME WITH THE ASSEMBLY TO MAKE SURE IT IS DONE RIGHT. REFER TO THE
WRITTEN INSTRUCTIONS , PICTURES, AND EXPLODED VIEW DRAWINGS
STEP 1 OPEN BAG 1 AND BAG 2 PLACE FOUR SPACERS THRU THE
HOLES NEAR THE FRONT OF THE CHASSIS AND ADD A NYLON
SPACER ON EACH. TO DETERMINE WHICH SIDE IS THE TOP OF THE
CHASSIS, NOTE THE OFFSET POSITION OF THE SERVO MOUNT
HOLES TO THE LEFT SIDE OF THE CHASSIS. ADD A THIN SPACER ON
EACH OF THE TWO FRONT SCREWS.
STEP 2 ADD THE FRONT AXLE PLATE ON THE FOUR SCREWS
AND RETAIN WITH FOUR LOCKNUTS.
STEP 3
OPEN THE KINGPIN BAG (INSIDE BAG 2) INSTALL A
THIN NUT ON EACH KINGPIN, INSERT IT INTO THE END OF THE
FRONT AXLE PLATE, ADD A LOCKNUT AND TIGHTEN, REPEAT
FOR THE OTHER SIDE.
STEP 4
PUT A DROP OF LIGHT OIL OR SILICONE LUBE ON EACH
KINGPIN AND INSTALL A STEERING BLOCK ON EACH ONE WITH
THE ANGLED PORTION POINTING IN. RETAIN EACH ONE WITH AN E-
CLIP. SNAP AN E-CLIP ON ONE END OF EACH STUB AXLE AND
PUSH THEM INTO THE STEERING BLOCKS FROM THE INSIDE.
STEP 5 OPEN BAG 3. ATTACH THE NITRO BOTTOM PLATE ON
THE REAR OF THE CHASSIS WITH TWO LONG SCREWS(3/8).
THREAD THE ALUMINUM THROTTLE PLATE SUPPORTS ONTO THE
SCREWS AND TIGHTEN THEM. NOTE THAT THERE ARE TWO SETS
OF HOLES IN THE PLATE SO THAT YOU CAN CHANGE THE REAR
OFFSET AS NEEDED ONCE YOU INSTALL YOUR ENGINE .
1
