STEP 12
SLIDE THE HUB/GEAR ON THE AXLE AND RETAIN
WITH TWO 10-32 SET SCREWS.TIGHTEN EACH CAREFULLY.
PLASTIC CAN BE STRIPPED IF OVERTIGHTENED. FILING A
FLAT SPOT ON THE AXLE FOR EACH SET SCREW WOULD
MAKE IT MORE SECURE. INSTALL A NYLON AXLE SPACER ON
THE AXLE AND SLIDE IT THRU THE BUSHINGS. ADD TWO AXLE
SPACERS ON THE END AND ADD THE OTHER HUB.TIGHTEN
EACH SET SCREW A LITTLE AT A TIME. OVERTIGHTENING ONE
WILL WARP THE HUB.
STEP 13
OPEN BAG 9 INSTALL THE PINION GEAR ON THE
MOTOR YOU HAVE CHOSEN. INSTALL THE MOTOR WITH TWO
3MM SCREWS AND WASHERS . MAKE SURE THE PINION IS
LINED UP WITH THE AXLE GEAR. ADJUST THE MOTOR SO
THERE IS A SMALL AMOUNT OF PLAY BETWEEN THE GEARS,
AND TIGHTEN THE SCREWS. TURN THE AXLE A COUPLE OF
TIMES AND RECHECK THE GEAR MESH.
STEP 12
STEP 13
STEP 14
OPEN BAG 7. INSTALL A BUSHING IN EACH SIDE
OF EACH FRONT WHEEL. PUT A SMALL AMOUNT OF LUBE ON
EACH FRONT AXLE, INSTALL THE WHEELS AND RETAIN WITH
E-CLIPS.
STEP 14
STEP 15
INSTALL EACH REAR WHEEL WITH TWO 3/8 CAP
SCREWS FROM BAG 4.
STEP 15
STEP 16
STEP 16
ATTACH YOUR STEERING SERVO TO
THE CHASSIS WITH SERVO TAPE, POSTS, OR
SCREWS IF YOUR SERVO HAS SIDE MOUNTS.
INSTALL PREBENT LINKS AND ATTACH TO-
GETHER WITH 1/8 COLLARS AND SET SCREWS .
TRIM THE LENGTH OF THE LINKS AS NECES-
SARY. ADJUST THE STEERING WITH THE SERVO
SAVER STRAIGHT UP AND THE WHEELS
ALIGNED.
3
