Riverstone Networks RS 3000, Getting Started Manual

Page: 41 / 103

Riverstone Networks RS 3000 Switch Router Getting Started Guide 2-21
Introduction Hardware Features
Dual Serial and Quad Serial – C/CE line cards
The Dual Serial line card contains a single dual serial WAN port (two serial ports located on one high density
connector). The Quad Serial – C and Quad Serial – CE line cards each contain two dual serial WAN ports. In addition,
the Quad Serial – C line card includes compression, and the Quad Serial – CE line card includes compression and
encryption.
Figure 2-10 shows the front panel of the Dual Serial WAN line card.
Figure 2-10 Front panel of the Dual Serial WAN line card
Figure 2-11 shows the front panel of the Quad Serial WAN line card with compression.
Figure 2-11 Front panel of the Quad Serial – C WAN line card
Figure 2-12 shows the front panel of the Quad Serial WAN line card with compression and encryption.
Figure 2-12 Front panel of the Quad – CE WAN line card
Per-GBIC LINK Green – indicates that the port hardware detects a cable plugged into the port and a good link
is established.
Red (intermittent) – indicates that port hardware received an error during operation.
Red (solid) – indicates that the port hardware detects a cable plugged into the port, however, a
bad link is established.
Off – indicates that no link from the port exists.
Table 2-15 MPLS GBIC line card LEDs (Continued)
LED Description
1,2
Tx
Rx
Link
Dual Serial G2M-SERAC-02
1 2
1,2
Tx
Rx
Link
Quad Serial - C G2M-SECAC-04
1 2
3,4
Tx
Rx
Link
3 4
1,2
Tx
Rx
Link
Quad Serial - CE G2M-SCEAC-04
1 2
3,4
Tx
Rx
Link
3 4