Check for parts online at www.HuntRiversEdge.com or call 800-345-6007 M-F 8-5
22
Operator's Manual
LOCKDOWN 2-MAN Ladder Stand
14. Once the straps (56) and carabiner (58) are all the way up the back
of the tree, unhook the tether rope (57) from the two long straps
(56) and set aside. The tether rope can later be used as a haul line
to pull your gear up into the stand. Feed the straps down through
the ladder ratchets (27) and ratchet a few cranks just to hold
the straps in place. SEE FIGURES 9 A-D for proper use of ladder
ratchets. Do not fully ratchet the straps tight yet.
15. Fully collapse the telescoping stabilizer bar (6) and install to the
ladder using one wing bolt (42) and wing nut (40). SEE FIGURE
10. When the stabilizer bar is fully collapsed and the lever handles
are aligned on the top, the three holes in the first three sections
should line up.
16. Extend the bark-biter end of the stabilizer bar until it contacts
the tree. Adjust the length of the stabilizer bar as needed and
make sure it is parallel with the ground. Align the nearest hole
and insert a wing bolt (42) and wing nut (40) and hand tighten
to secure the length of the stabilizer bar. SEE FIGURE 10. Then
attach the 8’ ratchet strap (55) by forming a cinch knot around the
stabilizer bar with both ends. SEE FIGURE 11. Wrap around the
tree and ratchet tight.
17. Now that the stabilizer bar is installed, you can finish tightening
the ground level ratchets (27) to secure the stand to the tree.
18. This ground level ladder-to-tree attachment will prevent the
ladder from pulling away from the tree while ascending to the
top for the final ratchet strap attachment. The same holds true
when ladder removal is necessary. You are now ready to climb
up and complete the final installation steps.
FIGURE 9-A
FIGURE 9-B
FIGURE 9-C
FIGURE 9-D
FIGURE 10 / STEP 15
FIGURE 11
6
55
6
42
40
40
42
