Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
9
Operator's Manual
DELUXE Ladder Stand
FIGURE
7
FIGURE
8
FIGURE
8A
FIGURE
8B
35
34
14. Attach the two long ends of the 16’ criss-cross straps (35) to
the platform frame tubes (5) near the tree blade. These long
stabilizer straps should be attached by pulling the free end of
the strap through the loop end of the strap to create a cinch
knot around the frame tube. SEE FIGURE 8A AND 8B.
15. To aid in the ease of installation, pre-attach each end of the
6’ ratchet strap (34) to each side of the platform frame tubes
(5) between the 16’ criss cross straps (35) and the tree blade.
Use the same method as above. SEE FIGURE 8B. This way
each end of the main ratchet strap is pre-attached before
the stand is lifted from the ground.
16. Attach removable seat (16) to the metal seat frame by
wrapping buckle straps around seat frame and secure
together. Pull straps tight so seat is not loose.
17. Attach shooting rail pads (15) to the shooting rail tubes
(12, 13) with hook and loop attachment strips on the pads.
Attach the armrest pads (14) to the armrests (11) with the
hook and loop attachments.
13. Slide the stabilizer bar (8) into the stabilizer support bar (9) and
secure using a lockpin (24). Make sure the lockpin passes through
the support bar (9) and the stabilizer bar (8) at the appropriate
hole to achieve the desired distance from the tree. Adjustment in
length may be needed when ladder is uprighted later in the Setup
and Use Instructions. Connect the stabilizer bar assembly through
the middle ladder section with stabilizer slot (27). These components
will be connected using a lockpin (24). SEE FIGURE 7.
NOTE: Treestand should ALWAYS be fully assembled
on the ground prior to mounting it in the tree.
8
9
24
24
27
35
34
