Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
4
Operator's Manual
CLASSIC XT 1-Man Ladder Stand
WARNING
BEFORE EACH USE PERFORM THE FOLLOWING:
• Inspect all webbing, rope, cord, and strap assemblies for
wear or damage.
• Inspect cables and/or cable ends for damage or kinking.
• Inspect all hardware and chain components for damage or
wear.
• Inspect for any structural damage to product. (If any exists
stop use immediately and call RETI Customer Service.)
• Inspect all nut and bolt assemblies to be certain none are
loose.
• Inspect for any missing parts.
• Lubricate all pivot and slide together points with powder
graphite, petroleum jelly or silicone spray to prevent noise,
wear and rust.
• Inspect entire product for any rust, corrosion, cracks,
freezing, excessive heat or rotting damage that may effect
the safety of your product. Discard any questionable
product.
• Inspect entire product for any structural damage - pay
close attention to all weld locations. (Discard product if any
damage is found.)
• Using correct wrenches inspect all nut & bolt assembly
locations and snug up any that may be loose. Be careful not
to crush tubing when tightening!
• Inspect and check operation of all cables, cable ends, cord,
rope, webbing, and strap or chain assemblies. Replace
with RETI original replacement parts any item or assembly
that shows signs of wear, damage, kinking, or functions
incorrectly.
• Inspect seat for damage or wear. Replace any seat with
factory new that shows signs of structural damage or wear.
• Never modify your stand in any way by making repairs,
replacing parts, or altering by adding or attaching anything
to it except if explicitly authorized in writing by the
manufacturer.
WARNING
INSPECTION AND MAINTENANCE
Always lean forward as you climb and attach your harness
to the tree before securing the platform to the tree and
stepping onto the platform.
Never exceed the stated maximum use height.
Do Not use this product until you have watched the
online safety video, understand it, and practiced the
techniques for safe hunting discussed in this video. Video
can be found with the QR code and/or URL shown on
front cover of this manual.
Read and perform all inspection and maintenance tasks
before each and every use. Replace any questionable
components immediately with RETI original replacement
parts.
Do Not crush tubing when tightening bolt assemblies!
Identify and familiarize yourself with all parts before you
start. Bolt identification chart can be found on the follow-
ing page of the manual.
Double check assembly steps to be certain you have
correctly assembled this product.
Never use any product that has not been maintained or
inspected properly - Your life depends on it!
Replace any and all treestand straps every two years or
when any signs of damage or wear exist before.
Always wear the appropriate footwear when using a
ladder treestand. A good non-slip safety boot is import-
ant to your personal safety. Be especially careful that
boot laces do not get hooked on the stand or any of its
components (tuck shoelaces into boots before climbing).
Only use approved RETI parts. Failure to do so may result
in serious injury or death!
