Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
7
Operator's Manual
BOWMAN™ Ladder Stand
ASSEMBLY INSTRUCTIONS
IMPORTANT ASSEMBLY TIP:
Do not tighten any nut and bolt combinations completely
until all parts are assembled together! Finger tighten plus
one turn of a wrench only! This will temporarily hold the
lock- nut on the bolt while helping alignment of all parts!
After all parts are assembled together, all nut and bolt combi-
nations must be completely tightened.
All assembly must be done in this order at ground
level before uprighting.
Do not remove labels/warnings from product, they are
there for your safety.
Recommended for adult use only.
FIGURE
1
FIGURE
2
NOTE: When selecting a tree to install the treestand in, never use
a treestand on a dead, leaning, diseased or loose barked tree, or
a utility pole. Always avoid electrical power lines.
1. Attach the two flatbar tabs (4) to the platform (1) using four 1/4-20
X 1-1/2 IN bolts (23) and four 1/4-20 nuts (15). SEE FIGURE 1.
NOTE: Do not tighten all nut and bolt assemblies completely!
2. Attach the two flared rails (5) to the two flat bar tabs (4) using two
1/4-20 X 1-3/4 IN bolts (24), two washers (14) and two 1/4-20 nuts
(15). SEE FIGURE 1.
3. Insert the crimped end of flared rails (5) into the side rails (7).
Secure together using two 1/4-20 X 1-1/2 IN bolts (23), two
washers (14) and two 1/4-20 nuts (15). SEE FIGURE 2.
4. Attach the tree blade (8) to the two side rails (7) using four 1/4-20
X 2-1/2 IN bolts (26), two washers (14), and two 1/4-20 nuts (15).
SEE FIGURE 2.
1
5
24
15
26
15
14
7
8
23
15
5
Mesh hidden for clarity
23
4
14
Summary of Contents for BOWMAN RE635
Page 6: ......
