`
©
2014 Riverdi
Page 3 of 7
www.riverdi.com
Hermes Board
datasheet Rev.1.2
Figure 1. Riverdi demo application
1.
QUICK START GUIDE
Warning!
Hermes Board will not work with 2.8” module. Channing interface from 8080 to RGB require 9bit SPI
which can’t be generated by FT232. For more detail about interface go to datasheet for specific
module.
Connect TFT module via CN1 ZIF0520DH connector. Select backlight power supply on CN3. Connect
Hermes Board to PC. Install Virtual COM Port drivers for FT232H. Drivers are available on FTDI
webpage:
http://www.ftdichip.com/Drivers/VCP.htm.
Launch Riverdi demo application. Select proper display.
2.
DEVELOPMENT KIT SET
Hermes Board kit contains:
Hermes Board,
20 pin, 0.5mm, 15 cm length FFC
1.5 m Micro USB cable
