1. POSITION THE DEVICE
You can mount the Access Point (AP) to a wall or ceiling using the attached snap disk.
If you do not require a solid mount, you can use the AP as a desktop unit.
For best radio coverage, ceiling mount the AP.
The AP ships with the rack mount hardware.
2. CONNECT THE POWER
Supply the AP with power using either the power supply (12 VDC, 2.0 A) or a
PoE injector (48 VDC, 0.5 A).
3. CONNECT TO THE NETWORK
Connect the AP to your local network. To find a SteelConnect Manager instance,
the AP needs Internet access; make sure the network provides a DHCP service
so the AP can establish a connection automatically.
Need help?
Riverbed Technology | 680 Folsom Street | San Francisco, CA 94107
[email protected] | (415) 247-7381 | www.riverbed.com
WEEE-Reg.-Nr. DE 36272080
LED LIGHTS
Green: Power | Orange: Ethernet
LEDs turn off when the AP enters normal operation mode.
FACTORY RESET
To reset the AP to its factory state, press the reset button on the back panel for
10 seconds. After releasing the button, all five LEDs flash and the AP resets to the
factory default state.
TEMPERATURE RANGES
Operating temperature: 0°C - 40°C | 32°F - 104°F
Storage temperature: -20°C - 60°C | -4°F - 140°F
For more information, go to https://support.riverbed.com.
Part Number 712-00281-01
