6
Rack Installation Guide
Rack Installation Guide
Mounting Series 1050 and 2050 to a Rack
Important:
Series 250 and 550 systems are designed for side to side airflow. If you install these systems in a rack do not
place objects on the sides of the system; it causes restricted airflow and can damage the system.
To install mounting brackets to the system
1.
Carefully lift the system out of the shipping carton.
2.
To install the mounting brackets, use the included screw kit to secure the brackets onto the sides of the
chassis (at the front of the system) using three screws on each side.
Figure 2. Installing Brackets to the Desktop System
3.
To mount the brackets to the posts, slide the system into the rack until the front is flush against the rack
posts. Install the included washer and screw in the center hole of the bracket. The Series 250 and 550
must be installed in a front mount.
4.
Insert and tighten the rack post screws on each side of the system.
Mounting Series 1050 and 2050 to a Rack
The following section describes how to install a Series 1050 and 2050 system in a four or two-post rack. It
includes the following sections:
“To open the bezel on Series 1050 and 2050 systems,”
next
“Mounting the RMK-002A Rails for 1050 and 2050 Systems” on page 7
