R Series V1.0 p 4
have the correct power cord. Our 230-volt export unit can be used with any of these
voltages. For Japan 100VAC models, all instructions for the 115VAC models apply. For
some markets that experience high Mains voltages, a special 250VAC version is
available.
In the event that you have questions, comments, or suggestions, please contact us at:
RIVERA
13310 Ralston Ave.
Sylmar, CA 91342 USA
Phone: (818) 833-7066
Fax: (818) 833-9656
Internet e-mail: [email protected]
No Time To Read This Manual? At Least Read This Part Now!
Before you plug in:
Take a quick look inside the back of your amp. Make sure of the following--
1. The tubes are securely seated in their sockets (see information on checking for loose
tubes).
2. The internal speaker's cord is plugged into the Speaker 1 output (this jack must
always be used first).
3. The power cord is plugged in.
4. The FS-7 footswitch is plugged in (this is optional).
Now look at the front to make sure:
1. The Volume and Master controls are set at low levels (2 is a good starting point).
2. The Power switch is off (the lower half is pushed in).
3. The Standby switch is set to standby mode (the lower half is pushed in-not applicable
for the R30).
Plug
in
!
Now plug the amp into the wall, plug your guitar into either input jack, and set your
controls to one of the Quick Start settings outlined here. Then turn on the Power switch.
Wait for about a minute for the tubes to warm up. Turn on the Standby switch. Now it's
time to rock.
After you've played with your Rivera for a while, check out the rest of the manual for
some good tips on getting the most out of your amp.
