Riva RE110, Installation Manual, Page: 9 / 20

9
www.rivatech.de
4 4 4 4.... CONNECTIONS CONNECTIONS CONNECTIONS CONNECTIONS
4 4 4 4....1 1 1 1.Connectors .Connectors .Connectors .Connectors
Video
Video Video
Video connection
connection connection
connection
Connect the camera to the Video input connectors
Video input connectors Video input connectors
Video input connectors on the back panel using 75 ohm
video coaxial cables with a BNC connector. Each video channel input among these
connections can be looped to other equipments as CRT monitor through External External External External
Video output connector Video output connector Video output connector Video output connector.
Make sure to connect the analog video input before you turn on the
encoder. Otherwise, the device must be rebooted to see the
normal display if the camera is NTSC, because the encoder default
setting is PAL without a video connection.
Audio connection Audio connection Audio connection Audio connection
Connect to the audio input device such as a Mic.
Audio input range: 0.01/3.3 (Min/Max)
Sensor Input (D/I) Sensor Input (D/I) Sensor Input (D/I) Sensor Input (D/I)
There are two sensor interface types – Voltage Type and Relay Type. The interface
type can be controlled by the software. Before connecting sensors, check driving
voltage and output signal type of the sensor. Since the connection is different
according to sensor type, be careful to connect the sensor.
Note
i
Mic
Ain
Speak
Aou