8
www.rivatech.de
3. INSTALLATION
1) Secure three screws in top of
camera’s main body as three unit holders
with metal rings attached in the end.
2) Connect all necessary cables to a PCB
board in a cover shield before conjoining
the shield to a camera’s main body.
3) Under the PCB board has a 32-pin
connector which matches the main
camera body’s 32-pin socket; The shield’s
three unit holder holes also align with the
main camera body’s three unit holders.
4) Once cable connect is complete along
with brackets and poles on an installation
spot, align the connector (of the cover
shield) and socket (of the main body), and
then push the main body to conjoin
together.
5) Once two units are attached, rotate
the main camera body counterclockwise
to secure the lock.
6) Insert three screws on top cover shield
and tighten them up.
To prevent products from damaging, place the camera on stable and non-
vibrating surfaces. If the stability is in doubt, consult with safety personnel
for reinforcements, and then proceed with the installation.
Caution
!