RC Series
RC362HD-6211IR Installation Guide
04-2017-A
www.rivatech.de
16
6.3. Reboot
Perform the following procedures to rest your device:
1.
Press the reset button, and hold for 2 seconds while the device is in use.
2.
Wait for the system to reboot.
Caution
!
Please do not hold the reset button for more than 2 seconds. Otherwise, the
camera may be switched to its Factory Default settings.
6.4. Factory Default
Resetting the device back to the factory default will initialize all parameters including the IP
address back to the factory defaults. To reset back to the factory default:
1.
Press the reset button, and hold it while the device is in use.
2.
Release the button after 10 seconds.
3.
Wait for the system to reboot.
Note
i
The factory default settings can be inferred as follows:
IP address:
192.168.xx.yy
Network mask:
255.255.0.0
Gateway:
192.168.0.1
User ID:
root
Password:
pass
6.5. Safe Mode
What is Safe Mode?
There may be certain occasions that your camera repeatedly fails to boot. Then, your camera
may enter safe mode to be recovered from the occasions.
What may have caused Safe Mode?
Here below are the main typical causes.
* The power supply is continually unplugged certain times in the middle of system booting.
* The firmware files required for system booting are damaged.
* There are conflicts in the system settings.