RC210309-2014-A
2
Caution
!
2. Install IP device
There are only two mounting types explained in this manual. Refer to the device’s installation guide for more
various mounting types.
Semi-Flush Mount
1)
Place the installation template included in
the package on the desired installation surface.
2)
Drill holes on the correct spots based on the
template paper, and insert the anchor blocks
into the holes.
3)
Open the dome cover.
*Refer to the caution below for the details about
how to open the cover.
4)
Connect necessary cables including a LAN
cable and a power cable to the camera.
5)
Hold the camera against the surface where
the camera will be mounted by matching the
alignment holes with the corresponding anchor
blocks.
6)
Route the cables through the cable hole at
the bottom of the camera, and tighten the
anchor blocks with the screws.
7)
Attach the dome cover on the main body,
and lock it up by rotating the dome cover.
*Refer to the caution below for the details of how to
attach the dome cover.
When placing the dome cover, look for the carved triangle mark on both dome cover
and main body. Both triangles should be aligned together when placing the cover. Once
the cover has been placed, rotate the dome cover clockwise for a secure lock. To
detach the cover, rotate the cover counterclockwise. Then, align the two triangle marks
each other, and pull the cover.
To prevent products from damage, place the camera on a stable and non-vibrating
surface. If the stability is in doubt, consult safety personnel for reinforcements, and
then proceed with the installation.
Caution
!
