For assistance, call RITRON at 800-USA-1-USA (800-872-1872) or visit us at www.ritron.com
qtm9322b.pm5
FIG.-7: QUICK ASSIST
INSTALLATION
QUICK ASSIST II INSTALLATION
WHEN YOU ARE FINISHED PROGRAMMING:
1. Hang up and disconnect
the telephone from the
internal jack on the
Quick Assist II
.
2. Test the operation
of the
Quick Assist II
before
putting it into service by activating the front switch. Listen to
the message received on your radio.
3. Replace the cover
and (4) cover screws. Snug down,
but
do not overtighten the screws
; excessive
force can break the plastic enclosure material.
6. Test for sufficient broadcast range
when choos-
ing the location for the
Quick Assist II
unit. For maximum
range and coverage, install it as high from ground level as
possible. Be aware that metal or wires; such as, steel or
concrete walls or metal shelving near the unit can block or
absorb radio transmissions.
7. Position the unit
as shown in FIG.-7, and secure it in
place with screws through the enclosure flanges.
Do
not overtighten
these screws, as you might break the
plastic flanges.
IMPORTANT: Contact a qualified technician or
electrician if you are not certain
your installation will work properly
and safely.
Pre-drilled Mounting
Hole
11
IMPORTANT: Contact a qualified technician
or electrician if you are not
certain your installation will
work properly and safely.
Pre-drilled Mounting
Hole
®
