RADIO PROGRAMMING
Have questions? Call
800-USA-1-USA
(800-872-1872) or visit our website at
page
16
HOW TO DELETE A CHANNEL
Following the instructions in “How to Field Program Frequency &
Tone Codes” on page 13, enter a Frequency Code of “00” and a
Tone Code of “00”. Once a channel has been deleted it is no longer
available with the Channel Selector.
A deleted channel can be added back at any time. To add a deleted
channel back, follow the instructions in “How to Field Program
Frequency & Tone Codes” on page 13.
PC PROGRAMMABLE FEATURES
The MURS base station has many features that are only available
through PC programming. See your Ritron dealer or contact Ritron
directly for PC programming of these options.
Squelch Tightener
on any channel can adjust carrier squelch UP to
block distant signals or DOWN to hear more distant signals.
Monitor Lock Out
can be set on any channel to prevent monitoring
of the channel, only broadcasts with the correct QC or DQC code
can be heard.
Transmit Inhibit on Busy Channel
can be set on any channel to
prevent transmitting when a broadcast is present on the receiver that
does not carry the correct code. This feature is usually used in
conjunction with Monitor Lock Out.
Transmit Time Out
time can be changed.
Power Saver
“sleep” time can be set, or power saver can be
disabled.
Courtesy Beep
sounds a short tone at the end of each received
transmission to indicate that the channel is clear and you may
transmit.
Transmit Clear To Talk Beep
Any channel can be set to sound a
short tone after the PTT has been pressed to indicate that the base
station is ready for you to begin talking.
Disable Field Programming
to allow only PC programming.
Channel Scan
can be programmed or edited to include any of the
radio channels, even channels that are not selected with the
Channel Selector button. Other programmable scan features include
scan resume delay time, busy channel blocking, last active channel
beeps, and priority scanning options.
2-Tone Paging Decode
can be set on any channel. Programmable
options include the setting of the 2-Tone frequencies and duration,
All Call, Group Call, Call Transpond, automatic setting of 2-Tone
Decode when the channel is selected, automatic reset of the 2-Tone
Decode if a call is not answered within 15 seconds, and
automatically set the base station to carrier squelch mode after a 2-
Tone signal is received.
* 2-Tone Encode
Each channel can be programmed with a unique
pair of 2-Tone encode frequencies between 300-1500 Hz. Pressing
the “Z” button will send the 2-Tone Code.
* DTMF ANI
A unique
DTMF ANI
string can be programmed
separately for each channel.
Pressing the “Z” button will send the
DTMF ANI.
* Note:
A channel can not be programmed to do both DTMF ANI
and 2-Tone Encode.
