PG
9
PG
10
TEMPORARY
TEMPORARY
override -
• At the Manual screen, Touch the
Temp Up / Temp Down
arrows
to select your desired temporary Target Temperature.
• Touch HOME to return to operation.
The
TEMPORARY
icon will flash indicating you have modified the
Target Temp for the current Time Slot only.
The 8085c has 3 manual override commands. These are accessed by
touching the Current Temp Display at the HOME screen (center of screen).
Target Temperature
HOLD
Touch this area to set
a comfortable target
temp for the system
to hold until you return
and remove
HOLD.
EMER
-For HEAT PUMP users only-
Touch this to engage
auxiliary heat source.
Return HOME
Temp Up / Temp Down
arrows
Touch these to raise and lower
the manual override Target Temp.
Manual Override
indicator shows when
a temporary override has been made.
MANUAL override screen
HOLD
-
• At the Manual override screen, Touch
HOLD
to a hold temperature.
• Touch the
Temp Up / Temp Down
arrows to select your hold temp.
• Touch HOME to return to operation.
The HOLD icon will flash indicating you have changed the Target Temp.
The system will HOLD this temperature until you return to this screen
and
de-select
HOLD, by touching the HOLD icon again.
EMER
(for HEAT PUMP users with auxiliary heat only) -
This function allows you to manually select AUX heat only in case the Heat Pump
fails or cannot keep up with demand for heat.
• Touch the
EMER
icon and
EMER ON
will flash. This turns on the AUX heat.
• Touch HOME to return to operation.
NOTE FOR HEAT PUMP USERS: In HEAT PUMP operation, there is a 5 minute delay from
shutting the compressor off and turning it back on. This is true for HEAT and COOL. This is to
protect against compressor stall. However, this 5 minute delay is terminated when unit is
switched to OFF. So wait 5 minutes before switching through OFF to either HEAT or COOL.
The Mode Switch must be in
HEAT
or
COOL
mode to override.