Riso MH 9350, User Manual

Page: 66 / 218

Chapter 3 Functions for Master Making
64
■
[Green/Red]
When printing with green and red drum colors,
the original is separated at optimum conditions.
10
Touch [OK].
11
Set the other required printing
conditions.
(
A
52 “Functions for Master Making”)
12
Press the [START] key.
Scanning of the original starts.
13
Check if separation is performed
as intended.
The [Preview] screen (
A
83) is displayed after
scanning the original.
• Touch [Continue] to start master making.
• Touch [Editor] to move to the [Editor] editing
screen. You can use the touch panel to
change the areas that you want to separate.
[Specified area]
Select this option for originals that contain photos.
Using a commercially available red marker pen, draw
frames (pen frames) directly on the areas that you
want to separate on the original.
A range of 1 mm to 3 mm (3/64 inch to 1/8 inch) is
available for the pen width.
The original is separated into inside and outside of the
specified area.
1
Draw pen frames to enclose the
areas that you want to separate on
the original.
Original Separation result
B
When using [Specified area], you can-
not select [Auto] under [Contrast].
B
Ensure that the ends of the pen
frame are connected. If the ends
are not connected, the line is not
recognized as a pen frame.
B
Keep the line width of the pen
frame between 1 mm and 3 mm
(3/64 inches and 1/8 inches). If the
line width is less than 1 mm (3/64
inches) or greater than 3 mm (1/8
inches), the line is not recognized
as a pen frame.
B
If a frame is smaller than a 10 mm
× 10 mm (13/32 inches × 13/32
inches) square, the frame is not
recognized as a pen frame.
Original
Print result
Print drum (cylinder) 1
(Outside the areas)
Print drum (cylinder) 2
(Inside the areas)
Correct Wrong
1 mm (3/64 inches)
(2.8 pt)
3 mm (1/8 inches)
(8.5 pt)