Riso MH 9350, User Manual

Page: 174 / 218

Chapter 9 Replacing Consumables
172
3
Pull out the print drum (cylinder).
Pull out the print drum (cylinder) slowly as far
as it will go while grasping the print drum (cylin-
der) handle.
4
Remove the print drum (cylinder).
Use both hands to lift the print drum (cylinder)
straight up and remove it from the rail. Firmly
grasp the blue handle section.
Installing the print drum (cylinder)
1
Place the print drum (cylinder) on
the rail.
Align the [
V
] mark on the print drum (cylinder)
with the [
M
] mark on the rail. Place the print
drum (cylinder) on the rail horizontally.
2
Return the print drum (cylinder) to
this machine.
Push in the print drum (cylinder) slowly as far
as it will go.
B
When the master making unit is
pulled out, you cannot pull out the
print drum (cylinder). Return the
master making unit to its original
position, and then press [Print Drum
(Cylinder) Release Button].
B
Do not touch the connector on
the print drum (cylinder). Neglect-
ing this may result in a malfunc-
tion of the print drum (cylinder)
because of static electricity or
other factors.
Print drum (cylinder) handle
B
If the print drum (cylinder) was
manually rotated, be sure to
return it so that the [
V
] and [
M
]
marks align after the procedure is
complete.
B
When pushing in the print drum
(cylinder), do not grasp the print
drum (cylinder) handle.