Chapter 7. Setting Guide for each Configuration
7.2.5
Save & Reboot
To reflect the setting to the WiComm-1, click the [
Save & Reboot]
on the Save & Reboot button on the Save &
Reboot sub-menu.
Figure 7-10. Infrastructure Mode Save & Reboot
If the WiComm-1 is rebooted, the wireless LAN IP is changed into the IP set in Wireless Network Configuration on
the Networks Settings submenu. To access the WiComm-1 with the specified wireless IP, perform the ping test by
using a PC (with the IP assigned by the AP) within the AP area. If the ping test is normally performed, the wireless
LAN of the WiComm-1 is normally working.
Now, the WiComm-1 setting for
Infrastructure Mode
is completed.
7.2.6
Serial Loopback Test
If the above setting is completed and the ping test is normally is performed, connect the serial port of the WiComm-
1 to Loopback. (Connect receive/transmit pins. e.g., connect pin 3 to pin 5 for RS232 communication).
After that, install the Com Redirector program contained in the CD provided to use the serial port of the WiComm-1
like the serial port of a PC.
Connect the COM port registered as the serial port of the WiComm-1 by using the serial communication emulator
program and perform the test.
Note
For the detailed installation method for the Com Redirector program, refer to the Com
Redirector installation manual contained in the CD provided.
7-10
