ENGLISH
ESPAÑOL
FRANÇAIS
7
OPERATING INSTRUCTIONS
Getting Started and Bluetooth® Pairing
1. Use unit’s Power switch on the back panel to turn unit ON (I Position).
2. Once the unit is turned on, you will see a slowly blinking blue indicator light.
In this mode, the unit’s Bluetooth mode is turned on, but is not in pairing
mode. [If you have already paired and connected a device, the blue LED will
be steadily lit.]
3. Press the Bluetooth Pairing
button for 4 seconds to have the speaker
system enter pairing mode. The speaker will beep twice and the blue indica-
tor light will flash rapidly, putting the speaker in Bluetooth pairing mode for
approximately 10 minutes (before turning pairing off again).
4. Activate your other device’s Bluetooth function (you might refer to your de-
vice’s user’s guide). The speaker should connect to any Bluetooth certified
device within 30 feet..
5. When “Mavis” appears in the Bluetooth devices list, pair it to your device.
Once the device is paired & connected to the Speaker’s Bluetooth receiver,
the indicator light will turn to steady blue, and the speaker should emit a
single beep.
Playing Music Through Bluetooth (after Pairing)
1. You can control the speaker through your device or with the speaker’s Play/
Pause
and Volume (
and
) buttons, found on the top panel.
2. If a smartphone is connected and you receive a call during playback, an-
swering the call using the phone will put the speaker into standby mode &
it will mute. Once the call is disconnected, the speaker will resume playback
automatically (provided the phone is using a compatible Bluetooth version).
3. If the connected device moves too far away from the speaker (usually more
than 30 feet or less if blocked by walls, for example) the speaker discon-
nects from the device but will attempt to resume connection once the de-
vice is closer.
Playing Music Through Auxiliary input Jack
The unit also supports listening and playing media off other
non-Bluetooth devices as follows:
1. Plug in the high quality 3.5mm (1/8”) male-to-male connector auxiliary cable
(included) into the Aux-In jack on the rear of the unit and connect the other
end to the line-out or headphone jack of any standard audio device.
2. Once the AUX cable is attached to the back panel port labeled AUX, the
status indicator light will turn amber, indicating unit is using line in mode
instead of Bluetooth mode.
3. Both the top panel volume buttons and the connected device’s controls
can be used to adjust the volume. Play music from your attached device as
