11 |
P a g e
1.7
FLOOR ANCHOR BRACKETS INSTALLATION
1.7.1
Concrete Footing or Concrete Pad Anchoring
1.
Place a floor anchor bracket at the designated location and orient it in the proper way.
2.
Apply tape to the drill bit to mark the 2” depth required for the 2-3/4” Vibration Resistant Hammer-On Stud Anchor you
will be using to anchor the bracket to the concrete footing or pad.
3.
Drill into the concrete through the four holes in the bracket bottom plate and into the concrete using a hammer
drill and ½” masonry drill bit. Drill minimum 2-1/4” deep and maximum 2-3/8” depth. Do not drill less than 2-1/4”
depth as the anchor will not pinch the bracket down fully if the hole is less than 2” deep.
4.
Using compressed air, blow out the drilling dust out of all holes. Compressed air cans are available at most stores.
