Rinnai RHFE-201FA, Owner'S Operation And Installation Manual

Page: 8 / 40

8
Rinnai Corporation RHFE-201FA
Operating Information
Turning the heater ON
When you press the ON/OFF button, the LED
display will illuminate, the spark will ignite the
main burner and the combustion fan will begin to
run.
This heater has an automatic ignition system.
When the main burner has lit, the combustion
lamp will glow red, and the spark will stop.
If ignition does not occur after 15 seconds, the
appliance will automatically turn off and fault code
11 will be displayed on the control panel. This
may occur when using the appliance for the first
time or if it has not been used for a while. Try
operating the appliance again.
There may be a smell of burning dust or oil the
first time the heater is lit or when the heater has
been out of operation for a long time.
The appliance may make noises after ignition or
when it is turned off. This is normal and is due to
the thermal expansion or contraction of its
components.
Adjusting the Temperature
The temperature setting and the room
temperature are indicated by the L.E.D. display
on the control panel. When the appliance is
turned on the temperature setting will be
displayed for 10 seconds. The display will then
show the room temperature. The default
temperature setting is 72 F.
To change the temperature setting press one of
the temperature control buttons once. The Set
Temp should light up and the display will show
the current temperature setting. Continue to
press the control buttons until the desired
temperature setting is reached. After 10 seconds
the display will return to showing the room
temperature.
The thermostat automatically modulates the
burner and the fan to maintain the temperature
setting.
The temperature settings available are:
LO - burner is on minimum combustion
60 F - 80 F in two deg ree increments
HI - burner is on maximum combustion
Turning the heater OFF
Press the ON/OFF button. Do not
turn off by unplugging at the power
outlet.
The fan will continue to run for a short time to
prevent the internal components from
overheating.
Economy Mode
Pressing the Economy button will
cause the appliance to go into
Economy Mode and the green lamp
will glow. This results in the
temperature setting being reduced
by 2 F, 30 minutes after the room
temperature has reached the
temperature setting. After another
30 minutes the temperature setting
is reduced another 2 F. This could result in the
temperature setting being reduced by a maximum
of 4 F. The intent of this mode is to save energy.
ON
ON/OFF
Filter
ON/OFF
RoomTemp
Set Temp
Temp
Control
Economy