
Rinnai
9
Touch Wi-Fi Kit IM
Table 2. Operating Indicators
FRONT VIEW
1
PWR
Power on/Primary module operation indication
2
BUS
Networker system communication indication
3
Wi-Fi
Wi-Fi module operation indication
4
SER
Not used
REAR VIEW
5
USB
Not used
6
Plug Pack Socket
12V DC
Supplied in the kit is a power adaptor which steps down the supplied voltage from 240VAC to 12V DC.
The 12V DC terminal end inserts into the ‘Plug Pack Socket’ on the Wi-Fi Module. In NC-7 based systems if
three or less NC-7 Touch controllers are installed the power adaptor is not required.
7
PWR
The Power ON/OFF button isolates power to the device, disabling system control through the App. The DC
power supplied from the TW1 & TW2 terminals on the Wi-Fi module is not impacted from this power isolation.
8
AP
This button allows the Wi-Fi Module to be forced to its Default AP State. To do this follow the procedure as
outlined below.
1. Switch Power OFF to the Wi-Fi Module
2. Press the AP button.
3. While pressing the AP button, switch power ON to the Wi-Fi Module.
4. Keep pressing the AP button until the Wi-Fi LED flashes orange.
9
Networker NC-7
Touch Connection
When three or less NC-7 Touch controllers are installed the loom supplied with the Wi-Fi kit provides both the
power and communication connections. One end of the 20m loom connects to the ‘Touch Connection’ socket
on the Wi-Fi Module and the other to a spare socket on the NC-7 Interface Module in Figure 4 on Page 12.
10
2-Wire Bus
Connections
The 2-wire bus connection terminal block facilitates 2-wire bus connection of heating/cooling appliances,
NC-3/NC-6 Networker controls and NT-1 Sensors.
Summary of Contents for N-BW2
Page 2: ......