4
HW_CF MC-601Q OIM Issue 1 -Oct 2017
Universal Water Controller (MC-601Q) Installation
1. Determine the most suitable position, refer "Location" on page 3.
2.
Mark and drill 3 holes (mounting and cable access) as per the dimensions (mm) below.
3. When running cable through the access hole ensure the connector end of the cable is located nearest to the
water controller (Fig. 1).
4.
Carefully remove the cover plates from the water controller, using a screw driver (Fig. 2).
5. Connect the cable to the water controller. Feed any excess cable lengths into the wall cavity to avoid the
pinching of cables between the wall and the water controller.
6. Fix the water controller to the wall using the appropriate fixings (Fig. 3).
7. Remove protective film from the water controller face and replace the cover plates (Fig. 4).
Optional Programming For Universal Water Controllers (MC-601Q)
QUESTION
?
1
Are there four water controllers connected?
IF NO:
You have three (or fewer) water controllers, go to Question 2.
IF YES:
You will need to activate the fourth water controller as follows:
STEP 1:
For the water controller in the KITCHEN ONLY, press and hold the ‘Priority
Transfer’ and ‘On/Off’ buttons simultaneously (see Fig. 1) until a ‘beep’ is heard
(approximately 5 seconds).
STEP 2:
Check that the display on ALL FOUR water controllers is lit and displaying a
temperature when ‘switched on’. If any ONE of the water controllers displays
two dashes (see Fig. 2) repeat STEP 1.
This completes the activation procedure for the fourth water controller, you
may ignore Question 2.
QUESTION
?
2
Is the water heater marked to state it delivers water not exceeding 50°C?
IF YES:
No further action required.
IF NO:
You will need to program the kitchen water controller to enable selection of
temperatures higher than 50°C.
STEP 1:
For the water controller in the KITCHEN ONLY, press and hold the ‘Priority
Transfer’ and ‘On/Off’ buttons simultaneously (Fig. 3) until a ‘beep’ is heard
(approximately 5 seconds).
STEP 2:
When the water controller fitted in the KITCHEN is switched On, it should be
possible to select temperatures higher than 50°C. If not, repeat STEP 1.
NOTE
If the water controller in the kitchen is replaced, repeat
STEP 1
for the replacement controller.
If the water controller in the kitchen is swapped with another water controller (for example, the
water controller fitted in a bathroom), repeat
STEP 1
for the water controller moved from the
kitchen to the bathroom. Then perform
STEP 1
for the water controller moved from bathroom
to the kitchen.
Connector
Controller Cable
Screws
Film
Fig. 1
Dimensions
Fig. 2
Fig. 3
Fig. 4
Cover
Plates
90
120
Ø20
84
Centre
Fig. 1
Fig. 2
Fig. 3
INSTALLATION