Rinnai New Zealand
Wireless Installation and Operation: C 03-09
Wireless Water Controller Installation
Installing wireless water controllers
Ensure the power to the water heater is switched on.
Press the ‘Entry’ button on the transceiver for approximately 2
seconds. This will select a wireless controller channel for tuning. The
first unassigned wireless controller channel LED will begin a fast flash,
signifying this channel has been selected for tuning.
The default order of channel selection is as follows: ---> MC ---> No.
---> No. 2 ---> No. 3
Select a wireless controller for tuning to the unassigned transceiver channel, insert
batteries and close battery compartment. after battery installation the controller will
momentarily display an initialisation screen (a), that will switch to screen (B) or (C).
If screen (B) is displayed, press and hold the ‘On/Off’ button until screen (C) is displayed.
This takes approximately 2 seconds.
From screen (C), press the ‘On/Off’ button once to start the tuning process which will take
approximately 5 seconds. Once the controller is tuned the controller channel LED on the
transceiver will become steady and the controller will switch to screen (D) or (E).
From screen (D) press the ‘On/Off’ button once or from screen (E) press the ‘Transfer’
button once to complete tuning of this channel. at this point screen (F) will be displayed.
The wireless controller is now tuned and ready to control delivery temperature of the water
heater.
apply one of the self-adhesive identification stickers to the rear of the controller, ensuring
that the Master Controller sticker is only applied to the wireless controller tuned to channel
MC.
The wireless master controller is the only wireless controller of selecting maximum delivery
temperatures exceeding 50 °C.
.
2.
3.
4.
5.
6.
Entry
Entry
Controllers
MC
No. 1
No. 2
No. 3
(C)
O R
Press for
approximately
3 seconds
(B)
(D)
(E)
Press once
(A)
Press once
to start the tuning
process, this takes
approximately
5 seconds
Press once
O R
(F)
Installing multiple wireless water controllers
To install subsequent wireless water controllers, repeat steps 1 - 6 for each additional
controller. Screw transceiver cover in place once all wireless controllers are installed.