The flow divider (Fig.5) can modify the speed of the tool’s motors.
PATENTED DEVICE “RSA” FOR AUTOMATIC SHIFTING MECHANICAL CONTROL
The patent device “RSA” controls the side shifting of the machine when it goes near the line of the trees.
The side shift is counted every time the sensor leave the trees. And the machine stop at the distance set.
In this way the position of the machine and in particular of the working head does not depend on the position of the
tractor in the row anymore.
In case that the tractor is too close at the row, the machine (if programmed following
our instructions) does not go too much into the row.
To modify the side shifting of the “RSA” press “set” on the box, then increase or
degrease the number of counting that appears on the small screen with the small arrow
form bottoms.
The best range of work is between 15 and 20 step.
Then press the bottom “F” to memorize the change or wait for 50 seconds for the
automatic memorizing.
In case the control device looses its program, this can be reprogrammed following the
schedule behind: press SET.
Part
Description
Definition
1
F1
Operation OUT 1
3
2
F2
Operation OUT 2
0
3
H1
Set for max computation
50
4
C
Computation
1
5
r
Restart time
10
6
H
Input max frequency
5
7
d
Time – sharing computation
1
8
B
Back-up
2
9
E
Input operation RES
1
10
t
Frontal key operation F
1
The safety zone around plant stocks is determined exclusively by the position of the sensor (Fig.14 Table 3); the are
two different setting of this part:
- the first is the angle of the sensor that can be changed by loosen the nut (Fig.3T, Table 3) and rotate the sensor
attachment brackets (Fig.13, 14 and 15, Table 3) to the desired position by letting the screw (Fig.8T, Table 3) slide
along the slot at the base of the sensor support (Fig.18, Table 3), when it is moved to the desired position tighten the
nut.
- the second is the distance between the external side of the working head and the sensor that can be changed by
loosen the nuts (Fig.16 Table 3) which hold the plate (Fig. 15 Table 3) and slides the sensor, then tighten again the
nuts.
It is important to respect a distance of 10 cm between the working head and the sensor at the turning on of the led P2
inside the sensor support arm (Fig. 9 Table 3).
MAINTENANCE
Maintaining the machine in a perfect condition means it has a longer life expectancy and retains optimum
performance; thus regular small checks are necessary.
This allows for a perfect working order and good reliability.
Cleaning, lubrication and adjustment of the machine must be carried out when it has been turned off.
General safety measures
Do not allow unauthorized people to interfere with the machine.
Before carrying out checks or maintenance, verify that the machine is completely off.
Never put your fingers in the machine openings without protection.
Never align holes or with your fingers but only with the appropriate centering tools.
Do not touch tools without wearing the correct protective gloves.
Never use petrol, solvents or other inflammable liquids as detergents but use recommended non-
flammable and non-toxic commercial detergents to clean the machine.
While using compressed air to clean and/or dry machine parts protect your eyes with goggles and
Summary of Contents for 60790B
Page 4: ......
