Ring Automotive Limited,
Gelderd Road, Leeds LS12 6NA
ENGLAND
Tel: +44 (0)113 213 2000 Fax: +44 (0)113 231 0266
Email: [email protected]
Website: www.ringautomotive.com
L493
RECYCLING
This marking indicates that this product should not be disposed with
other household wastes throughout the 2012/19/EU. To prevent possible
harm to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable reuse of
material resources. To return your used device, please use the return
and collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.
MAINTENANCE INSTRUCTIONS
This charger requires minimal maintenance. As with any appliance or tool, a few common sense rules will prolong the life of the
battery charger.
ALWAYS BE SURE THE CHARGER IS UNPLUGGED BEFORE PERFORMING ANY MAINTENANCE OR CLEANING.
1. Store in a clean, dry place
2. Coil up the cords when not in use.
3. Clean the case and cords with a slightly damp cloth.
4. Clean any corrosion from the clamps with a solution of water and baking soda.
5. Examine the cords periodically for cracking or other damage and have them replaced if necessary.
6.
WARNING
: All other service should be done by qualified personnel only.
TECHNICAL DATA
Model RSC404
Input
220 - 240V AC 50Hz
Output
6V DC 2A 12V DC 2/4A
Error code
Condition
Possible Cause
Solution
Er1
The battery voltage is less than 0.5V
before charging.
The battery is defective.
Replace the battery.
The charge does not begin.
The battery clamps are disconnected
with the battery. The battery clamps
are connected to each other.
Connect the battery firmly and
correctly.
The battery voltage is not matched
with the selected mode.
Confirm that battery voltage is
matched with the mode.
Er2
The battery voltage is 0.5V - 1.5V
before charging.
The battery is defective.
Replace the battery.
The battery voltage is less than 11V
after 4 minutes of charging. The bat-
tery is not full charged after 24-hour
charge.
The battery is defective.
Replace the battery.
A load may be connected to the
battery.
Disconnect the load and attempt to
charge again.
The charge current is too low.
Select a higher charge rate.
The battery voltage is less than 12V
in 2 minutes after full charged.
The battery is sulphated beyond
reconditioning.
Replace the battery.
Er3
The temperature of the charger is
too high.
High ambient temperature.
Ensure adequate ventilation. The
charger will resume charging after
cooling.
TROUBLESHOOTING ERROR CODES
