Rimage Professional™ 3400 and 5400N Diagnostic Tests
2001497_A
3
Test 2 – Cycle Test Diagnostic
This test has 6 cycles. The cycles are determined by whether or not a disc is present and where it is placed in
the autoloader. The cycle beings when the autoloader detects the location of the disc, if present.
Important!
Before you begin diagnostic test 2, remove all discs from the autoloader. Make sure that the
printer tray, recorder trays, carousel, and output bin are empty.
Select Diagnostic Test 2
1.
Make sure the autoloader is in diagnostic test mode. Refer to the
Access and Select Diagnostic Tests
section on page 1.
2.
Press
button 1
twice and hold it until the operator panel displays
[02 CYCLE TEST SETUP DEVICES]
.
3.
Release
button 1
. The autoloader pauses, allowing you to place media in the appropriate place. Follow
the instructions on
for the cycle you wish to perform.
Tip:
Once media is placed and the devices are set up for a cycle, press and hold button 1 to display an
option menu on the operator panel. Each option displays for 3 seconds. Release button 1 while an
option is displayed to select the option and begin the cycle. Choose from the following options:
[02 CYCLE TEST EXIT W/O RUNNING]
[02 CYCLE TEST SIM OUTPUT FULL]
[02 CYCLE TEST SIM OUTPUT EMPTY]
[02CYCLE TEST SIM OUTPUT NORM]
Note:
The autoloader continues to perform each cycle until you press button 1 to stop it.
Cycle 1: Cycle a Disc at the Printer
1.
Select diagnostic test 2. Refer to page 3.
2.
Press the
printer tray button (button 2)
to open the printer tray.
3.
Place
one disc
on the printer tray.
4.
Press
button 1
to begin the cycle. The operator panel displays
[02 CYCLE TEST CHECKING DEVICES]
.
•
The lift arm picks and places the disc at the printer tray.
•
The operator panel displays
[02 CYCLE TEST CYCLE = XXXXXX]
, where X is the number of cycles
completed.
5.
Press
button 1
to stop the cycle and return to diagnostic test mode. The operator panel displays
[00
CHOOSE DIAGNOSTIC]
.
6.
Remove the
disc
from the printer tray.
7.
Press
button 2
to close the printer tray.
