Rimage Prism Install Manual Download Page 2

Page: 2 / 5

5. Slide the Print Ribbon onto the Supply Roller, as shown in the figure below.

Align the two Notches of the Cardboard Core to the Metal Pins on the Supply

Roller.

6. Peel the Ribbon Leader from the Supply Ribbon.

8. Pass the Ribbon Leader

under

the Ribbon Guide (metal shaft) as shown.

9. Tape the Ribbon Leader to the back of the Printer Drawer as shown above.

InstallingPrismRibbon.doc

2 of 5

Summary of Contents for Prism

Page 1: ... sunlight If you are replacing the ribbon now is a good time to clean the printhead Procedure 1 Power on the printer 2 Remove the top cover 3 Pull up the Take up Roller so the end with the gear comes up first as shown below and remove the Take up Roller out of the printer 4 Remove the Supply Roller by pulling up on the end as shown InstallingPrismRibbon doc 1 of 5 ...

Page 2: ...Notches of the Cardboard Core to the Metal Pins on the Supply Roller 6 Peel the Ribbon Leader from the Supply Ribbon 8 Pass the Ribbon Leader under the Ribbon Guide metal shaft as shown 9 Tape the Ribbon Leader to the back of the Printer Drawer as shown above InstallingPrismRibbon doc 2 of 5 ...

Page 3: ...ader 11 Push the Unit Attention button so that the printer drawer comes out This automatically threads the ribbon to the front of the printer 12 Remove the tape from the Printer Drawer 13 Remove the adhesive strip from the ribbon leader InstallingPrismRibbon doc 3 of 5 ...

Page 4: ...f the Ribbon Leader as shown The gear must be on the correct side 16 Pull the Ribbon Leader up over the Cardboard Core and attach the Adhesive Strip to the Cardboard Core so the edges on the Ribbon Leader are aligned to the edges of the Cardboard Core The arrow below illustrates the wrap direction InstallingPrismRibbon doc 4 of 5 ...